Skip to content

Deliveries

Self-loading pallet truck: how it lifts itself onto the truck

The pallet truck that travels with the load: how it gets onto the truck bed without a tail lift, step by step, with STAXX Vango data.

2 min readAuthor: AIOLOS LIFTS

STAXX Vango self-loading pallet truck

The short answer

A self-loading pallet truck is a pallet stacker that can load the pallet onto the truck bed first and then lift itself on board, with no tail lift or forklift needed. It travels with the load and unloads at the customer's premises. STAXX offers it as the Vango500 and Vango1000 (500 and 1,000 kg, electric lifting, manual travel) and as the fully electric Vango1000-E.

At a glance

Vango500Vango1000Vango1000-E
Lifting capacity500 kg1,000 kg1,000 kg
Load centre400 mm400 mm400 mm
Maximum fork height800 / 1,000 / 1,300 / 1,600 mm800 / 1,000 / 1,300 / 1,600 mm800 / 1,000 / 1,300 / 1,600 mm
TravelManualManualElectric, up to 3.5 km/h
Lift motor0.8 kW1.6 kW1.6 kW
Battery12 V gel, maintenance-free12 V gel, maintenance-free48 V / 25 Ah
Weight incl. battery214–260 kg285–324 kg342–377 kg

From the STAXX Vango500/1000 (2025) and Vango1000-E (2026.4) catalogues. Weight depends on mast height.

How it loads: the steps from the manual

  1. Pick up the pallet and lift it about 20 mm.
  2. Move to the rear of the truck bed and raise the pallet above the level of the truck bed floor.
  3. Approach until there is 0–50 mm between the machine and the truck bed, then set the pallet down inside.
  4. Using the relevant button, the machine raises its own body off the ground; pull out the rubber support legs.
  5. When the body reaches its highest point, retract the legs, lift the pallet again and push the machine and load inside.
  6. Set the pallet down in position and pull the machine back until it will not move any further. Close the door and set off.

Unloading is done in reverse order. The manufacturers warn not to pull the middle wheel out beyond the truck bed and to wait 3–5 seconds during lifting before moving away.

Which model suits your vehicle

  • Truck bed height: choose a fork height greater than the height of the truck bed floor (800–1,600 mm, depending on the version).
  • Load weight: up to 500 kg for the Vango500, up to 1,000 kg for the Vango1000 and Vango1000-E.
  • Delivery route: if the driver pushes the load several metres or up gentle slopes, the fully electric Vango1000-E (5% gradeability when laden) is less tiring. The semi-electric Vango must not be used on ramps.
  • Space in the vehicle: the Vango1000-E has a compact design so it takes up little space on the truck bed.

Who it is for

For deliveries with a van or small truck without a tail lift: beverages, food, building materials, spare parts, shop equipment. Because the machine travels with the load, the driver unloads alone at every stop, with no need for a forklift at the recipient's site.

See them in action

Videos from the manufacturer's (STAXX) official YouTube channel.

Machines in this article

See photos, catalogues and CE certificates for each model.

Frequently asked questions

It is a pallet stacker that loads the pallet and then lifts itself onto the vehicle's truck bed, so it can unload at the destination without a forklift or tail lift.

Sources